Krick Florida Mode D'emploi page 27

Make dry pauses between the individual gluing
processes.
The glue edge can now finally be sanded
clean.
Stage 2, Preparing the interior construction,
parts 2.1 - 2.3
Fig. positioning the RC plate
The RC-plate 2.1 is needed to fit the transom
reinforcement.
Cover part 2.1 at the rear edge with an adhe-
sive strip over the whole width to prevent stick-
ing.
Fit the RC mounting plate to the transom, posi-
tion it provisionally in the fuselage and fix it in
place with strips of adhesive tape.
Fig. gluing in transom reinforcement
Glue the transom reinforcement to the transom
of the hull in such a way that the 12 mm hole in
the hull and in the reinforcement match. The
reinforcement should rest on the RC plate.
Remove any excess adhesive immediately and
allow the glued joint to dry.
Status April 2020
2.1
2.2
2.1
Seite 5
Fig. preparing the rudder support
Insert the rudder support 2.3 into the transom,
align it and fix it with adhesive tape. Pre-drill
the holes in the transom with Ø 1.5 mm.
The rudder holder and the rudder can, if de-
sired, be painted now.
Remove the RC mounting plate and rudder
support again.
Stage 3, Assembly of the rudder (Z-Drive),
parts 3.1 - 3.15
3.2
3.1
Fig. rudder and rudder support
Insert the rudder 3.1 into the rudder support
2.3 and fix it rotatably with screw 3.2 and stop
nut 3.3.
3.5
3.6
3.4
Fig. universal joint
Assemble the universal joint from parts 3.4 and
3.5 and screw in set screws 3.6.
©
Krick Modelltechnik, Knittlingen, Germany
2.3
Ø 1,5 mm
2.3
3.3
3.6
3.4