Publicité
Les langues disponibles
Les langues disponibles
Cockpit
Nose
Fig. cutting the cockpit to size
Cut out the cockpit in the edge.
ATTENTION: The insertion lug "N" in the front
area must remain in place, as it will later serve
as a lock.
Clean the outer surrounding edge of the cock-
pit 7.1 with a sanding block and fit it so that the
cockpit fits well into the notch in the deck.
N
Fig. cockpit with locking device
Insert the cockpit into the deck opening, fitting
the nose "N" so that it sits in the recess at the
front. The cockpit must fit completely in the
surrounding deck groove.
Fig. fitting the nose
Status April 2020
Fig. holes for steering wheel and throttle
Drill the holes for the steering wheel and throt-
tle according to the markings.
Fig. hole for compass housing
Drill the centre of the hole for the compass
housing between the two instrument bumps,
20 mm from the front edge.
Pre-drill with a small drill and then, preferably
with a peeler drill (body drill), drill to 14 mm
until the compass housing part 7.9 can be
inserted.
Fig. hole for compass housing
Seite 10
Ø 3 mm
Ø 2 mm
20 mm
Compass Housing
Body Drill
©
Krick Modelltechnik, Knittlingen, Germany
Publicité
