Krick Florida Mode D'emploi page 26

Fig. mar rking the cut- -out for skylig
Align pa rt 7.25 as tem mplate for th
the deck k and mark th he inner edge
Fig. mar rking for cuto out
Remove e the cut-out at the mark a
with a file e.
Sand the e surfaces to o be glued in
around f fold in deck e edge).
Fig. adhe esive surface e in the deck
At this po oint it is advi isable to drill
the stern n tube at the bottom (6 m
rudder li nkage (12 m mm) at the ma
stern of f fuselage 1.2 . Pre-drill the
smaller d drills first, an nd widen them
using lar rger drills or a scraper dr
The adh esive surfac es are marke
hatching g in the pictur res.
Status Ap pril 2020
ght
e cut-out on
e.
and smooth it
deck ( all
k edge
the holes fo or
mm) and for th he
arks on the
e holes with
m step by ste ep
ill.
ed with black k
Seite e 4
1.2
Fi ig. adhesive surfaces
C lean and san nd all gluing
ha atched) in hu ull 1.2.
In nsert the hull into the fold
ch heck the fit. I f necessary,
Fi ig. connectin ng hull and de
P ull hull and d deck togethe
w ith adhesive tape strips t
an nd warping.
D ot both parts s together at
su uperglue.
Fi ig. gluing hul ll and deck
St tarting in the e bow area, d
th he fold. Now swing the bo
gl ue runs alon ng the gluing
pr rocess along g the edge of
ab ble bond betw ween hull an
©
Krick Modelltech K
surfaces (bla ack
of the deck and
, trim the hul l.
eck
r at several p points
to prevent dis stortion
several poin nts with
drip superglu e into
oat hull so th at the
edge. Repe eat this
f the hull unti l a reli-
nd deck is ac chieved.
hnik, Knittlingen , Germany