Krick Florida Mode D'emploi page 34

7.5
7.3
Fig. parts for the steering wheel
Glue the centre part 7.6 and the wheel rim part
7.4 onto the steering wheel part 7.3. Glue the
two hubs part 7.5 to the back of the steering
wheel.
Fig. wheel rim and centre glued on
Fig. wheel hub glued on
Now round off the steering wheel on all edges.
Fig. Steering wheel sanded
Status April 2020
7.6
7.4
Fig. painted steering wheel
Finally glue in the steering wheel axle part 7.2.
Fig. Parts for throttle lever
Make the throttle lever from parts 7.7 to 7.9
Push the wire 7.7 through the base and place it
centrally.
Fig. wire in the base centered
Bend both ends upwards.
Fig. wire ends bent over
Seite 12
7.8
7.7
©
Krick Modelltechnik, Knittlingen, Germany
7.9