Publicité
Les langues disponibles
Les langues disponibles
This fixes the drive unit in the fuselage.
Fig. drive unit positioned
Glue the stern tube in the hull end and the
transom sealing from the inside with Stabilit
Express.
Glue the support brackets to the hull and the
coupling flange with Stabilit.
Fig. gluing in the drive train
glue
Fig. glue in RC-plate
Position the RC-plate 2.1 finally and glue it with
Stabilit Express.
Stage 6, RC-installation, parts 6.1 - 6.12
Moisten the Z-boom 3.12 or the folded bellows.
Slide the bellows over the linkage onto the
socket of the rudder support. Ensure good all-
round tightness.
Status April 2020
glue
Seite 8
Fig. bellows mounted
Fig. lubrication nipple
Place the lubrication nipple part 6.16 on the
sterntube and screw it with screws 6.17. Glue it
to the sterntube with super glue. Finally drill
through the lubrication nipple with a Ø 2.5 mm
drill bit through the sterntube.
ATTENTION: Pull the shaft out of the sterntube
before drilling, so that the shaft is not dam-
aged.
Assemble the servo mount from parts 6.3 to
6.5.
6.3
Fig. parts for servo mount
Fig. servo mount assembled
©
Krick Modelltechnik, Knittlingen, Germany
6.5
6.4
Publicité
