Krick Florida Mode D'emploi page 29

Fig. coup pling
Slide the e spacer ring g 4.5 onto the
the moto or 4.1 in flang ge 4.6 and fa
screws 4 4.7 and wash hers 4.8. Tigh
screws e evenly.
1 mm
4.5
Fig. moto or and coupl ling flange
Slide the e stern tube 4 4.9 with the s
coupling g flange.
Fig. coup pling flange f fixed and ste
serted
Slide the e clamping n ut 4.10 onto
and tight ten it so that at the other
emerges s from the ste erntube with
length of f the flattenin ng.
Fig. shaf ft protrusion
Status Ap pril 2020
e motor. Plac ce
asten it with
hten the
4.6
4.10 0
4.7
4.8
shaft into the e
erntube in-
the housing
end the sha aft
the entire
Seite e 7
Ti ighten the gr rub screw in
N ow check by y hand or with
ch harged batte ry for smooth
sh haft. Hold the e motor and
St tage 5, Insta allation of th
Pa arts 5.1 - 5.2 2
G lue the 4 sup pport bracke
th hey are cong ruent.
Fi ig. support b rackets
S lide the brac ckets onto the
fla ange.
P lace the driv e unit in the
Fi ig. drive in th he hull
M Move the drive e unit so that
co omes out thro ough the hol
S lide the wash her 5.2 onto
Fi ig. sterntube placed with
Move the drive M e unit in the f
sh haft engages s in the unive
w ith the wash er resting ag
A pply cyano to o the suppor
fu uselage in thi is position.
©
Krick Modelltech K
the coupling .
h a moderate ely
h running of the
clutch housi ng firmly.
he drive,
ts 5.1 in pair rs so that
e pins of the coupling
fuselage.
t the stern tu ube
le in the tran som.
the shaft end d.
washer
fuselage so that the
ersal joint cou upling,
gainst the cou upling.
rt brackets in n the
hnik, Knittlingen , Germany