Publicité
Les langues disponibles
Les langues disponibles
Shorten the ends if necessary and glue on the
two handles.
Paint the throttle stick according to the chosen
colours and attach it to the cockpit.
Fig. throttle lever mounted
Note: The Florida is a single screw drive. But
the throttle has 2 levers. With the first one the
speed is controlled and the second one is the
switch from forward to reverse.
Now make the two seat shells from the balsa
wood parts 7.16 - 7.20.
7.20
7.17
7.16
Fig. balsa wood parts for seat shell
Glue parts 7.16 - 7.18 together to form the seat
shell. Glue 7.19 to part 7.20.
Fig. seat parts glued together
Sand the seat into shape and glue on the
headrest.
Status April 2020
7.19
7.18
Seite 13
Fig. seat glued and sanded
Then prime the seat shell with pore filler. After
the pore filler has dried, sand the seat shell
again. Perform this step 2-3 times. Then spray
the seat shell with primer until the wood grain
has disappeared and a uniformly smooth sur-
face is created.
Fig. seat shell sanded and primed
The seat shell can now be painted.
Now make the two seat frames from brass
tubes part 7.21 - 7.25.
For this purpose drill a hole Ø 2 mm in the
frame feet at a distance of 18 mm.
2 mm
Fig. frame foot with hole
Insert a pin part 7.24 into this hole.
©
Krick Modelltechnik, Knittlingen, Germany
18 mm
Publicité
