Publicité
Les langues disponibles
Les langues disponibles
The construction of the model
Step 0, the boat stand, parts 0.1 - 0.3
Glue together the boat stand from parts 0.1 -
0.3. Grind all glued edges with sandpaper to
remove the burn-off residue from the laser
cutting.
0.1
Fig. stand glued together
Stage 1, Preparation of deck and hull, parts
1.1 to 1.4
First cut off the inner area of deck 1.1 with
battery tray at the edge.
Fig. Cut off inner area
Fig. Cutting the edge to size
Cut off the outer edge of the deck evenly all
around 3 mm above the edge of the drawing.
Here you can proceed in 2 ways.
Use a 3 mm thick wooden strip as spacer.
Status April 2020
0.2
0.3
Cut here
3 mm
Seite 3
You can then either trace the contour with a
pencil or score the contour several times with a
knife until the overhang can be broken off.
Fig. Marking with pencil
Fig. Scoring with knife
Drill a 3 mm hole in deck 1.1 for the horn ac-
cording to the marking.
Fig. Drilling for horn
The edge of deck 1.1 is cut off at the marking.
Use a pair of strong scissors, e.g. Lexan scis-
sors, Krick No. 455 533, for this purpose. Only
roughly straighten and grind the cut edge, as
the exact finishing is done later.
©
Krick Modelltechnik, Knittlingen, Germany
1.1
Drill 3 mm
Publicité
