Lh101 Setup (Device Setting); Setting The Speed Step Mode - Lenz Digital plus LH101 Mode D'emploi

80

14 LH101 setup (device setting)

This section describes the possible settings of the LH101. These are
permanently saved in the LH101.

14.1 Setting the speed step mode

To control direction and speed, two methods are available:
Standard mode:
-
In this mode (ex-factory setting) you can decrease the speed step
to 0 using the rotary knob.
- Shunting mode:
In this mode you can decrease the speed step to 1 using the
rotary knob. Press the rotary knob to stop the locomotive. Let the
locomotive move slowly to the desired location and press the
rotary knob to stop the locomotive.
The advantage of this mode while shunting: You can decrease
the speed to the slowest setting without risking that the
locomotive stops to early and without having to look at the
manual control.
Do not confuse the shunting mode of the LH101 with the
shunting gear that can be set in locomotive decoders.
To set the shunting mode:
Action Display
Turn the rotary knob until the option "Setup
LH101/LH101 setup" is displayed.
Operating manual LH101
Explanation