Lenz Digital plus LH101 Mode D'emploi page 164

44
9 Displaying the fast clock
This feature can only be used when using the LZV200
central unit.
Before you can use the time display, you must set the
model time and the desired factor in the "Setup System" of
the LZV200 central unit.
In the lower line of the display, you can display the model time as an
alternative to the function status.
Aktion
If the model clock is switched off (factor=0), the information "time
stopped" is displayed in the lower line.
While you switch a function of the locomotive on or off (i.e.
press one of the keys 0 to 9), the fast clock display
disappears briefly and the function status is displayed for
approx. 1 second.
How to set the day of the week, the time and the factor is described in
section "Setting the fast clock" on page 99.
Display
Proceed from "Controlling locomotive".
With the '<=' key you change from the display
of the function status to the display of the fast
clock ...
... and back.
Operating manual LH101
Explanation