Preface And General Information; About These Operating Instructions; Terminology Used; Scope Of Supply - Lenze EPM-H510 Instructions De Mise En Service

Show/Hide Bookmarks

Preface and general information

1 Preface and general information
The EPM-H510 keypad can be used to access codes of lenze controllers, 9300 Servo PLC and Drive
PLC and control these units. Communication takes place via system bus (CAN).
The HMI Designer is a powerful development tool for creating projects containing the configuration
of the keypad.
1.1

About these Operating Instructions

These Operating Instructions are designed to describe safe and trouble-free working on and
!
with the EPM-H510 keypad.
All persons working on and with the EPM-H510 keypad must keep these Operating Instructions
!
to hand and observe all relevant information and notes.
These Operating Instructions must always be kept as a complete document and in a readable
!
state.
1.2

Terminology used

Term
Drive controller
HMI
1.3

Scope of supply

Scope of supply
•
1 EPM-H510 keypad
•
1 Operating Instructions
•
4 Fixing clamps
•
4 M4 screws 35 mm
•
1 Seal
•
1 Terminal strip, 4-pole for DC voltage supply
•
1 Terminal strip, 5-pole for system bus connection
(CAN)
44
In the following text used for
Lenze 8200 and 8200 vector frequency inverters, 9300 servo inverters
Human Machine Interface
Important
After receipt of the delivery, check immediately
whether the scope of supply matches the
accompanying papers. Lenze does not accept any
liability for deficiencies claimed subsequently.
Report
•
•
EDBEPM-H510 DE/EN/FR 4.0
visible transport damage immediately to the
forwarder.
visible deficiencies/incompleteness immediately to
your Lenze representative.
L