Cleaning The Interior; Main Components - Gastro M 70/40 FTG Serie Installation-Emploi-Entretien

- Undo the screw securing the element to the oven
and pull the element out by approx. 10 cm.
- Reassemble all parts. For assembly, proceed in
reverse order.
CONVECTION OVEN
REPLACING THE KNOB AND INDICATOR LIGHT
- Remove the control panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE WORKING THERMOSTAT AND
SAFETY THERMOSTAT
- Remove the control panel.
- Remove the bulb from its seat on the side of the
oven.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE HEATING ELEMENT
- Remove the oven floor (only for lower heating
elements).
- Undo the screw securing the element to the oven
and pull the element out by approx. 10 cm.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE MOTOR
- Remove the oven floor.
- Remove the interior panel
- Remove the engine support.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.

23. CLEANING THE INTERIOR

Check the condition of the inside of the appliance.
Remove any built-up dirt.
Check and clean the fumes exhaust system.

24. MAIN COMPONENTS

GAS FRY-TOP WITH TAP
- Gas tap
- Main burner
- pilot burner
- Thermocouple
- Igniter
- Piezoelectric ignition
GAS FRY-TOP WITH VALVE
- Gas valve
- Main burner
- pilot burner
- Thermocouple
- Piezoelectric ignition
- Safety thermostat
- Igniter
ELECTRIC FRY-TOP
- Working thermostat
- Safety thermostat
- Heating element
- Indicator light
ELECTRIC OVEN
- Control knob
- Working thermostat
- Safety thermostat
- Heating element
- Indicator light
CONVECTION OVEN
- Control knob
- Working thermostat
- Safety thermostat
- Heating element
- Indicator light
- engine
- fan
31