Gastro M 70/40 FTG Serie Installation-Emploi-Entretien page 30

AFTER REPLACING A GAS SYSTEM
COMPONENT, CHECK FOR GAS LEAKS
AT CONNECTION POINTS.
DISCONNECT THE APPLIANCE ELECTRIC
SUPPLY, IF PRESENT, BEFORE
CARRYING OUT ANY OPERATION.
AFTER REPLACING AN ELECTRICAL
SYSTEM COMPONENT, CHECK IT IS
CORRECTLY WIRED.
GAS FRY-TOP WITH TAP
REPLACING THE GAS TAP.
- Remove the control panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE BURNER, THE PILOT BURNER, THE
THERMOCOUPLE, THE PIEZOELECTRIC IGNITION
AND THE IGNITER
- Remove the control panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
GAS FRY-TOP WITH VALVE
REPLACING THE GAS
THERMOSTAT.
- Remove the control panel.
- Remove the bulb from its seat on the bottom of
the hotplate.
- Remove and replace the component.
- Insert the bulb properly in its seat on the bottom of
the hotplate.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE BURNER, THE PILOT BURNER, THE
THERMOCOUPLE, THE PIEZOELECTRIC IGNITION
VALVE AND SAFETY
AND THE IGNITER
- Remove the control panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
ELECTRIC FRY-TOP
REPLACING THE HEATING AND LIGHT GLOWS.
- Remove the control panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE WORKING THERMOSTAT AND
SAFETY THERMOSTAT
- Remove the control panel.
- Remove the bulb from its seat on the bottom of
the hotplate.
- Remove and replace the component.
- Insert the bulb properly in its seat on the bottom of
the hotplate.
- Reassemble all parts. For assembly, proceed in
reverse order.
ELECTRIC OVEN
REPLACING THE KNOB AND INDICATOR LIGHT
- Remove the control panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE WORKING THERMOSTAT AND
SAFETY THERMOSTAT
- Remove the control panel.
- Remove the bulb from its seat on the side of the
oven.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE HEATING ELEMENT
- Remove the oven floor (only for lower heating
elements).
30