Siemens SITRANS P500 Notice De Service page 6

1.2 History
This history establishes the correlation between the current documentation and the valid firmware of the device.
The documentation for this revision is applicable for the following firmware:
Revision Firmware and hardware
identity nameplate
02 FW: 35.01.00
09/2010
HW: 11.01.01
03 FW: 35.02.00
04/2013
HW: 11.01.01
to SP05
1)
1.3 Purpose
Overview
Depending on the variant, the pressure transmitter measures corrosive, non-corrosive and hazardous gases, vapors and
liquids.
With appropriate configuration, you can also use the differential pressure transmitter for the following measurement types:
● Level
● Volume
● Mass
● Volume flow
● Mass flow rate
The output signal is always a load-independent direct current between 4 and 20 mA upon which a HART protocol is
superimposed.
You can install the "Intrinsically safe" or "Flameproof enclosure" version of the transmitter in hazardous areas. The devices
have an EC type-examination certificate and meet the regulations applicable to them, for example, the harmonized
CENELEC standards in Europe.
Transmitters with remote seals of different shapes can be delivered for special applications. For example, measuring high-
viscosity substances is a special application.
Operate the device in accordance with the specifications in section Technical data (Page 27).
For additional information, please refer to the operating instructions for the device.
4
System integration
PDM 6.0 ; Dev. Rev.3
1)
DD; 01.00.00 Dev.
Rev.1
PDM 6.0 ; Dev. Rev.3
1)
DD; 01.00.00 Dev.
Rev.1
Installation path for
PDM
SITRANS P500
SITRANS P500
Note
SITRANS P500 with HART
A5E02344532-03, 04/2013