Sage the Barista Express Guide Rapide page 15

Descaling the coffee component
4.
Press the 1 CUP button to start the
descaling for the coffee component of the
machine. Descaling coffee component
takes approximately 25 seconds. The 1 CUP
button should flash continuously and remain
constant once the descaling process has
finished. To terminate the descaling within
25 seconds, press the 1 CUP button again.
Descale the steam and hot water
components
Descaling steam and hot water takes
approximately 13 seconds and 8 seconds
respectively. Descaling can be terminated
prematurely by turning the steam dial to STANDBY.
5. Descale Steam component by turning
the steam dial LEFT towards the STEAM icon.
6. Descale Hot water component by turning the
steam dial to the RIGHT towards the HOT
WATER icon.
Repeat processes to complete descaling
After the above processes about half
(0.5 litre) of the descale solution should
be left in the water tank.
7. Repeat steps 4-6 above to complete the
descaling process to empty the solution
in the tank.
Descaling Solution Rinse
8. After descaling, remove the water tank and
rinse thoroughly then refill with fresh cold water
to the maximum capacity (2 litres) and repeat
steps 4-6 to further cleanse the machine of any
residue of the cleaning solution thoroughly.
9. Press 'POWER' to quit the descaling process.
This will be indicated by the LED lights
switching off.
NOTE
The machine turns off automatically if there
is no action for 5 minutes in descaling mode.
To resume descaling, please start from step 3.
EN
15