Programming The Basic Settings - Raleigh Pedelec Mode D'emploi

Programming the Basic Settings

In general, all basic settings for your electric bicycle are pre-set. If you happen to change tire sizes, during
service, for example, you can reset the tire circumference to ensure the precise function of your speedo -
meter. Furthermore, you can set the unit to display the speed, the strength of the recharge when triggering
one of the two brake levers and the arrangement of the main functions. This is done by
entering programming codes.
Turn on the programming mode
Simultaneously push
of the selection with
desired program is displayed.
Code Description
2001
Select km/h or mph
2002 Regeneration/brake output (for magnetic switch) 0-40 (ideally 30-40)
2005
Tire circumference (millimeters)
2009 Flip Display Plus/Minus 0 = power left, 1 = power right
Code 2001
Select unit - km/h or mph. Select with
or and confi rm with
Code 2005
Set tire size (in mm) - Select digits
one after another with
confi rm with .
WARNING
Please do not use other programming codes without consulting your authorized dealer.
If you type the wrong code, please push
12
and until the display shows "0000". The fi rst zero blinks. Change the value
or and confi rm with
Code 2002
Default value: 30: adapt with
.
and . Confi rm with
Code 2009
Current setting of main functions is
or and displayed. Flip = 0, assist toggle is on
the right side of console; Flip = 1, assist
toggle is on the left side of console.
Confi rm with
. Select the other digits in the same manner until the
.
.
key to exit programming mode.