Charger; Troubleshooting - Raleigh Pedelec Mode D'emploi

7 Charger

Read the two stickers on the charger before using it for the
first time.
Do not use other chargers. Only charge the battery
using the charger provided, or a charger approved by
Derby Cycle.
If a fault develops or if the battery is in sleep mode, you
might be able to solve this problem by placing the battery
in the charger for one minute. The battery management
then checks the battery and can eliminate any faults that
have occurred.
If used incorrectly, the device may be damaged or
inflict injuries.
› Before cleaning the charger, always pull the plug
out of the socket to avoid a short-circuit and/or
physical injury.
› Only use the charger in dry rooms.
› Only place the charger in a secure stable position
on a suitable surface.
› Do not cover the charger or place any objects on
it as otherwise it could overheat and catch fire.

8 Troubleshooting

The control panel also indicates when faults and techni-
cal errors are present. If a fault occurs, the LEDs flash in a
specific pattern and with a specific rhythm. This indicates
the cause of the problem and makes it easier for you to
find a solution.
Control panel display
Have the electric drive inspected regularly by your
specialist cycle shop. Do not carry out any work on
the electric drive or battery yourself. Unless you have
sufficient expertise this could lead to a serious ac-
cident. As a basic rule, always consult your specialist
cycle shop if you have a problem with the electric
drive or the battery.
You should only have the electrical components of
your Pedelec replaced with genuine parts. This makes
it safer for you and avoids problems when processing
warranty claims.
IV User Manual Pedelec with front motor 17