Water Fill - Aircare 5D6700 Guide D'utilisation Et D'entretien

ASSEMBLY
1) Unpack humidifier from carton.
2) Remove all packaging material, wicks, etc. from cabinet.
3) Place the wicks in position by sliding them into the mounting ribs molded into the
bottom of the cabinet.
4) Insert the plastic platform with the circular cutout (transitional molding) on top of
the mounted wicks. Note that the transitional molding is notched and marked
"FRONT" to indicate proper placement.
Transitional
Molding
Cabinet/
Water reservoir
Replacement Parts Available For Purchase
Transitional Molding
Humidifier Wicks (2 Required)
Air Purifying Filter (Optional)

WATER FILL

CAUTION: Before filling, ensure unit is turned OFF and unplugged.
1)
Before replacing the chassis, fill the cabinet with unsoftened water. DO NOT
POUR WATER OVER THE ELECTRICAL CHASSIS. Fill the cabinet only
through the opening between the wick and the cabinet sidewall. Note the MAX.
notation on the side wall of the cabinet. DO NOT OVERFILL. Cabinet capacity is
3.0 gallons.
NOTE: We recommend using AIRCARE
when you refill the water reservoir to eliminate bacterial growth. Add bacteriostat
according to the instructions on the bottle.
Under no circumstances should you use Water Treatment products intended for
Rotobelt or Ultrasonic humidifiers.
ABOUT HUMIDITY
Where you set your desired humidity levels depends on your personal comfort
level, the outside temperature and the inside temperature.
NOTE: Recent CDC tests show that the chances of flu transmission are greatly
reduced at levels of 43% humidity.
You may wish to purchase a hygrometer* to measure the humidity level in your
home. Following is a chart of recommended humidity settings.
Air Intake Section of Grille
Digital Control Panel
Description
Air Exit
Section
of Grille
1040 Wicks
(2 required)
Optional 1050
Air Purifiing Filter
Part Number
1B71786
1040
1050
® ®
or Essick Air Bacteriostat Treatment
4
Chassis
BACK VIEW