Water Fill - Aircare 5D6700 Guide D'utilisation Et D'entretien

NOTES ON LOCATION
In order to get the most effective use from your humidifier, it is important to position
the unit where the most humidity is needed or where the moist air will be circulated
throughout the house such as near a cold air return. If the unit is positioned close to
a window, condensation may form on the window pane. If this occurs the unit should
be repositioned in another location.
Do NOT position the unit directly in front of a hot air duct or radiator. Do NOT place
on soft carpet.
Due to release of cool, moist air from the humidifier, it is best to direct air away from
thermostat and hot air registers. Position humidifier next to an inside wall on a level
place at least 4 inches away from the wall or curtains.
ASSEMBLY
1) Unpack humidifier from carton.
2) Remove all packaging material, wicks, etc. from cabinet.
3) Place the wicks in position by sliding them into the mounting ribs molded into the
bottom of the cabinet.
4) Insert the plastic platform with the circular cutout (transitional molding) on top of
the mounted wicks. Note that the transitional molding is notched and marked
"FRONT" to indicate proper placement.
Replacement Parts Available For Purchase
Transitional Molding
Humidifier Wicks (2 Required)
Air Purifying Filter (Optional)

WATER FILL

CAUTION: Before filling, ensure unit is turned OFF and unplugged.
1)
Before replacing the chassis, fill the cabinet with unsoftened water. DO NOT
POUR WATER OVER THE ELECTRICAL CHASSIS. Fill the cabinet only
through the opening between the wick and the cabinet sidewall. Note the MAX.
FILL notation on the side wall of the cabinet. DO NOT OVERFILL. Cabinet
capacity is 3.0 gallons.
NOTE: If only softened water is available, it can be used; however you will notice
a build-up of minerals on the evaporative wick much sooner.
:
Description Part Number
1B71786
1040(CN)
1050
4