Water Fill - Aircare MA1201 Guide D'utilisation Et D'entretien

WATER FILL

The bottle lifts straight up and away
from the base. Take care not to bump
or damage fill valve assembly on the
bottom of the bottle.
Remove the side fill cap and fill with
water. Replace cap and twist by hand
until secure. Hold the bottle upright
over the sink. Press up on the valve
plunger for one second to release a
small amount of water. If you hear air
bubbles or see leaks around the side
fill cap or Spring Valve Assembly,
retighten and recheck.
CAUTION: Use only EPA Registered Bacteriostat. Under no circumstances
should you use water treatment products designed for Rotobelt or Ultrasonic
humidifiers
Place the water bottle back into the humidifier base. When positioned properly,
the plunger will open and the water will flow into the base. The base will hold the
entire contents of the water bottle. Once the bottle is empty, remove it and repeat
the filling process. The humidifier is now filled to capacity. To benefit from less
frequent filling let the humidifier exhaust both the water from the bottle and the
base before filling.
OPERATION
This unit has a digital
control panel that
allows you to adjust fan
speed and humidity
level, as well as view
information on the
status of the unit
5