4-Step Buttonhole - Janome Jem Gold Livret D'instructions

Janome Jem Gold Instruction Manual
q
z
q
w
e
r
x c
t
n
www.toews.com
w e
v b
y

4-Step Buttonhole

Machine setting
q Stitch selector:
w Thread tension: 1 – 5
e Presser foot:
Sliding buttonhole foot
* For easier buttonhole foot attachment, move the slider
all the way to the front of the foot. For easier removal,
move the slider all the way to the back of the foot.
• To sew
z Set the pattern selector dial at "
Carefully mark buttonhole length on fabric.
Place the fabric under the foot with the buttonhole
marking running toward you.
Draw both the needle and bobbin thread to the left.
Move the slider toward you so that the top mark w on
the slider meets the start mark q.
q Start mark
w Top mark
e Needle thread
r Bobbin thread
NOTE:
The scale on the slider is engraved in centimeters.
x Sew forward until you reach the front marking of your
buttonhole. Stop sewing at a left stitch.
c Raise the needle to its highest position.
Set the pattern selector dial at "
then stop sewing at a right stitch.
v Raise the needle to its highest position.
Set the pattern selector dial at "
needle reaches the back marking of the buttonhole.
b Raise the needle to its highest position.
Set the pattern selector dial at "
then stop sewing.
n Raise the needle and presser foot. Remove the fabric
from the machine and cut the sewing thread. Insert a
pin inside the bartack.
Then cut the opening with a seam ripper.
Take care not to cut the stitches.
t Pin
y Seam ripper
44
Janome Sewing Machine
".
". Sew 5 stitches,
". Sew until the
". Sew 5 stitches,
Jem Gold Owners Manual/ User Guide