Janome Jem Gold Livret D'instructions page 44

Janome Jem Gold Instruction Manual
z
x
z
x
c
www.toews.com
To sew
zMake 1.5˝ (3~4 cm) cut along the seam line at the
beginning. Raise the presser foot.
Position the fabric under the presser foot with the lower
blade in the cut.
NOTE:
Thick fabric cannot be cut.
When turning the handwheel slowly, the built-in side
cutter may squeak. however, it is not a defect.
xLower the presser foot. Sew at the lowest speed as
possible.
CAUTION:
Never use the reverse stitch lever when using the side
cutter. It may break the needle.
To store the built-in side cutter
zSlide down the lever to raise the lower blade.
q Lever
q
xLower the presser foot.
Be sure that the thread take-up lever is at its highest
position.
Swing up the lever in the direction of arrow to store the
built-in side cutter in its original position.
CAUTIONS:
• Be sure to lower the foot when storing the built-in side
cutter, otherwise it hits the foot and will be damaged.
• Swing up the lever until it clicks and stops.
cRaise the presser foot. Replace the presser foot.
NOTE:
After using the built-in side cutter, remove the needle
plate.
Clean the feed dogs and hook area as lint and dust
will built up by cutting action.
38
Janome Sewing Machine
Jem Gold Owners Manual/ User Guide