Buttonhole - Janome 2041 Manuel D'instructions

Buttonhole

Models
( 2041SX, 2041NX, 2049SX, 2049LX
q Pattern selector:
w Presser foot:
e Thread tension:
r Stitch length:
t Stitch width:
* The size of buttonhole is automatically set by placing the
button in the automatic buttonhole foot.
* The button holder of the foot takes a button size up to
2.5 cm (1") in diameter.
* Make a test buttonhole on a sample duplicating the fabric,
interfacing and seams of the actual garment.
* Place the button on the fabric sample and mark the top and
bottom to determine the position of buttonhole.
* Use interfacing on stretch fabrics.
z Turn the handwheel toward you to raise the needle to
its highest position.
Raise the presser foot lifter.
x Select the pattern "BH" by turning the pattern selector
dial.
If the BH pattern is already selected, reset the dial once
according to the procedure in 2.
c Attach the automatic buttonhole foot.
v Pull the button holder to the back, and place the button
in it. Push back the button holder toward you as far as
it will go.
b Pull the buttonhole lever downward as far as it will go.
q Buttonhole lever
n Insert fabric under the foot.
Turn the handwheel slowly towards you with your right
hand until the needle goes down and continue turning
handwheel until the take-up lever is at its highest position.
m Remove the fabric to the left to draw both threads to
the left.
, Insert the garment under the foot, and lower the needle
at the starting point.
Then lower the automatic buttonhole foot.
Note:
Make sure there is no gap between the slider and the spring
holder. If there is a gap, the length of the rows will be different,
as shown.
w Starting point
e Slider
r There should be no gap
t Spring holder
y Difference
exclusive
(BH)
Automatic buttonhole foot
1–5
(0.25–1)
5
1
)
BH
A
L
K
J
H
I
1 2 3
4
5
6 7 8
44
2
4
2
C
1
3
D
E
4
F
G
1
2
3
5
2 3
4
1
0
5
0
3
4
5
6