Connecting The Machine To The Power Supply; Foot Control; Polarized Plug - Janome 2041 Manuel D'instructions

Connecting the Machine to the Power Supply

Before connecting the power cord, make sure the voltage and
frequency shown on the machine conform to your electrical
power.
1. Turn off the power switch.
2. Insert the machine plug into the machine socket.
3. Insert the power supply plug into the outlet .
4. Turn on the power switch to turn on the power and sewing
light.
1 Power supply plug
2 Power switch
3 Outlet
4 Machine socket
5 Machine plug

6 Foot control

Foot control
Sewing speed can be varied by the foot control.
The harder you press on the control, the faster the machine
runs.
Caution:
Do not place anything on the foot control, otherwise the
machine will start advertently.

Polarized Plug

This appliance has a polarized plug (one blade wider than the
other). To reduce the risk of an electric shock, this plug is
intended to fit in a polarized outlet only one way. If the plug
does not fit in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician to install the proper outlet. Do not
modify the plug in any way.
2
4
8
3
1
5
6