Table des Matières
Publicité
Buttonhole
(Model 2041S exclusive)
q Pattern selector:
w Presser foot:
e Thread tension:
r Stitch length:
To adjust buttonhole stitch density:
Set the stitch length dial between 0.5 and 1.0 to adjust the
buttonhole stitch density.
1
Carefully mark buttonhole length on fabric.
Place the fabric under the foot with the buttonhole
marking running toward you.
2
Move the slider (A) toward you so that the top mark (C)
on the slider meets the start mark (B). Line up the
markings on the foot with the top mark on the fabric.
Note:
The scale on the slider is engraved in centimeters.
3
Set the pattern selector dial at "
Sew forward until you reach the front marking of your
buttonhole.
Stop sewing at a left stitch.
4
Set the pattern selector dial at "
Sew 5 stitches. Stop sewing at a right stitch.
5
Set the pattern selector dial at "
Sew until you reach the back marking of the buttonhole.
Stop sewing at a right stitch.
6
Set the pattern selector dial at "
Sew a few bartacks and raise the needle from the fabric.
Set the stitch length dial to "0" and the pattern
selector dial at straight sewing.
Sew a few locking stitches.
7
Remove the fabric from the machine and cut the sewing
thread. Insert a pin inside the bartack.
Then cut the opening with a seam ripper.
Take care not to cut the stitches.
(BH)
Sliding buttonhole foot
1–5
(0.25–1)
".
".
".
".
1
A
B
1
4
2
C
3
H
D
E
G
F
3
4
1
2
(C)
(B)
3
4
7
50
2
4
2
1
3
4
0
2
1
0
(A)
5
3
6
Publicité
Table des Matières
