Attaching And Removing The Vacuum Bag; Installing The Shoulder Harness - Ryobi RESV1300 Manuel De L'opérateur

ATTACHING AND REMOVING THE VACUUM BAG

Attaching
1. Attach the vacuum bag to the vacuum bag hook on
the blower/vacuum tube (Fig. 3).
2. Slide the vacuum bag tube over the debris exhaust
tube on the housing. Push the tube until the latching
tabs on both sides click into place, securing the bag
on the unit (Fig. 4).
Latching Tabs
Removing
1. Press the latching tabs on both sides of the vacuum
bag tube and pull the vacuum bag down from the
unit (Fig. 5).
2. Detach the vacuum bag from the vacuum bag hook.
PRESS IN
8
ASSEMBLY INSTRUCTIONS
Vacuum Bag Hook
Fig. 3
Debris Exhaust Tube
Vacuum Bag Tube
Vacuum Bag
Zipper
Fig. 4
Latching Tabs
PRESS IN
Fig. 5

INSTALLING THE SHOULDER HARNESS

1. Push the strap through the center of the buckle.
2. Pull the strap over the cross bar and down through
the slot in the buckle (Fig. 6).
3. Snap the clip on to the support fitting (Fig. 7).
Clip
4. While standing in the operating position adjust length
to fit the operator's size. Pull tab to lengthen, pull
strap to shorten (Fig 8).
Clip
Fig. 6
Support Fitting
Fig. 7
Fig. 8