Specifications; Troubleshooting - Ryobi RESV1300 Manuel De L'opérateur

Motor Amperage.................................................................................................................................................... 12 Amps
Blower Air Output ...................................................................................................................... up to 160 mph (257.5 kmh)
Vacuum Air Flow............................................................................................................................. up to 424 cfm (12 cmm)
Mulching Ratio...................................................................................................................................................... up to 10:1
Operating Weight ........................................................................................................................................... 10 lb (4.5 kg)
Vacuum Bag Capacity .......................................................................................................................... .75 bushels (26.4 L)
UNIT WILL NOT BLOW OR VACUUM
C A U S E
Bag full
Blocked tube
Blocked impeller
Damaged impeller
Dirty bag
Torn bag
Bag unzipped
Unit unplugged
UNIT WILL NOT START
C A U S E
Unit is unplugged
Power/Speed switch is in the OFF position
If further assistance is required, contact your authorized service dealer.

SPECIFICATIONS

TROUBLESHOOTING

Empty bag, as described in Empty the Vacuum Bag
Clear the blockage as described in Clearing a Blocked
Tube/ Impeller
Clear the blockage as described in Clearing a Blocked
Tube/ Impeller
Take the unit to an authorized service dealer
Clean the vacuum bag
Replace the vacuum bag
Zip up the vacuum bag
Plug into an outlet or an extension cord
Check cord to make sure it is plugged into an electrical outlet
Slide switch to HIGH or LOW
A C T I O N
A C T I O N
15