Installing Line In Reel-Easy String Head; General Maintenance - Toro 51958 Manuel De L'opérateur

Installing Line in REEL-EASY
Head
See Figures 14 - 15.
1. Stop the engine and disconnect the spark plug wire.
2.
length.
3.
with arrows on top of string head.
4. Insert one end of line into eyelet located on either side
of the string head and push until line comes out through
eyelet on the other side. Continue to push line through
the string head until the middle section of the line is
inside the string head and line outside the string head is
evenly divided on each side.
5. While holding the string head in one hand with your
mm) remains protruding from the string head.
Maintenance
Normal maintenance, replacement or repair of emission con-
service for assistance.
WARNING:
Before inspecting, cleaning, or servicing the
parts to stop, and disconnect spark plug wire
and move it away from spark plug. Failure to
follow these instructions can result in serious
personal injury or property damage.
WARNING:
Always wear eye protection with side shields
hearing protection. Failure to do so could result
18
™ String
Line
Clockwise (51978
and 51978A
straight shaft)
-
WARNING:
When servicing, use only recommended or
-
parts could result in a personal injury hazard or
property damage.
NOTICE:
Periodically inspect the entire product for dam-
aged, missing, or loose parts such as screws,
ers and caps and do not operate this product
until all missing or damaged parts are replaced.
service center for assistance.

General Maintenance

Avoid using solvents when cleaning plastic parts. Most
Arrows
Figure 14
Counterclockwise
(51958 curved shaft)
Eyelet
Figure 15
-
Operation