Cutting Line - Toro 51556 Manuel De L'utilisateur

Tips For Maximizing Battery Life and
Performance
1. Do not store trimmer with battery in discharged
condition.
2. Charging time of 24 hours will restore a
discharged battery.
3. Your Toro trimmer is designed with over-charge
protection. It is recommended that you keep
charging for the entire cutting season.
4. Store fully charged trimmer in cool, dry location.
Do not store trimmer in direct sunlight or near
furnace.
5. For the winter or for idle periods of more than a
month, disconnect the charger from the wall
outlet and trimmer after the trimmer is fully
charged. Do not store the trimmer with the
charger plugged in. Storing trimmer in a warm
area will decrease life of battery. If trimmer must
be stored in a warm area, charge battery for 24
hours every 2–3 months when not in use.
6. IMPORTANT–Use only the Toro charger Part
No. 73–5410 supplied. Using a different charger
may damage the battery.
Battery Charging Procedure
POTENTIAL HAZARD
Charging produces explosives gasses.
WHAT CAN HAPPEN
Explosive gasses could cause personal
injury or property damage.
HOW TO AVOID THE HAZARD
Charge battery in a well-ventilated area
away from sparks, flames and smoking.
EN–6
1. Insert charger plug into receptacle located on the
power case (Fig. 7).
2. Hang trimmer upright from a solid hook (Fig. 8)
or lay trimmer on its side on a flat, solid surface
away from combustible liquids, gasses or
materials. Position trimmer on side as shown in
Figure 9.
3. Plug charger into 120 volt wall outlet. Be sure
outlet is turned on.
Note: The charger may become warm to the
touch. This is normal and does not
indicate a problem.
4. After battery has been properly charged, remove
charger from wall outlet then remove charge
plug from trimmer receptacle.

Cutting Line

Note: The cutting line for your trimmer is a
special monofilament line. Your
trimmer comes complete with a supply
of this line already wound onto the
spool.
1. To avoid line tangle during shipment, the tip of
the monofilament line has been taped to the head
assembly (Fig. 10). The tape must be removed
before operation.
2. After each use, either retaping or looping the line
through the eyelet will prevent unraveling of line
on spool (Fig. 11).