Rules For Safe Operation - Ryobi OGS1820 Manuel D'utilisation

GB
F D E

RULES FOR SAFE OPERATION

WARNING
The tools should be operated with the ONE+
battery pack.
When using battery operated tools basic safety
precaution should always be followed to
reduce the risk of fire, leaking batteries and
personal injury, including the following.
Read the operation manual and follow all warnings
and safety instructions.
Wear eye protection and ear protection.
Do not use this machine in wet weather
conditions!
Wear protective clothing and boots.
Wear non-slip, heavy duty gloves.
Keep all bystanders at least 15m away.
Sharp cutting blades. To prevent serious injury,
do not touch cutting blades.
Caution! Cutting means continues to run after
the motor is switched off.
GENERAL POWER TOOL SAFETY WARNINGS
WARNING
Read all safety warnings and all instructions.
Failure to follow the warnings and instructions
may result in electric shock, fire and/or serious
injury.
Save all warnings and instructions for future
■
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
WORK AREA SAFETY
Keep work area clean and well lit. Cluttered or dark
■
areas invite accidents.
Do not operate power tools in explosive atmospheres,
■
such as in the presence of fl ammable liquids, gases or
I P NL S DK N FIN GR HU CZ RU
English
dust. Power tools create sparks which may ignite the
dust or fumes.
Keep children and bystanders away while operating
■
a power tool. Distractions can cause you to lose
control.
ELECTRICAL SAFETY
Power tool plugs must match the outlet. Never modify
■
the plug in any way. Do not use any adapter plugs with
earthed (grounded) power tools. Unmodifi ed plugs and
matching outlets will reduce risk of electric shock.
Avoid body contact with earthed or grounded surfaces,
■
such as pipes, radiators, ranges and refrigerators. There
is an increased risk of electric shock if your body is
earthed or grounded.
Do not expose power tools to rain or wet conditions.
■
Water entering a power tool will increase the risk of
electric shock.
Do not abuse the cord. Never use the cord for carrying,
■
pulling or unplugging the power tool. Keep cord away
from heat, oil, sharp edges or moving parts. Damaged
or entangled cords increase the risk of electric shock.
If operating a power tool in a damp location is
■
unavoidable, use a residual current device (RCD)
protected supply. Use of an RCD reduces the risk of
electric shock.
When operating a power tool outdoors, use an extension
■
cord suitable for outdoor use. Use of a cord suitable for
outdoor use reduces the risk of electric shock.
NOTE: The term "residual current device (RCD)" may
be replaced by the term "ground fault circuit interrupter
(GFCI)" or "earth leakage circuit breaker (ELCB)".
PERSONAL SAFETY
Stay alert, watch what you are doing and use common
■
sense when operating a power tool. Do not use a power
tool while you are tired or under the infl uence of drugs,
alcohol or medication. A moment of inattention while
operating power tools may result in serious personal
injury.
Use personal protective equipment. Always wear eye
■
protection. Protective equipment such as dust mask,
non-skid safety shoes, hard hat, or hearing protection
used for appropriate conditions will reduce personal
injuries.
Prevent unintentional starting. Ensure the switch is in the
■
off-position before connecting to power source and/or
battery pack, picking up or carrying the tool. Carrying
8
RO PL SLO HR TR EST LT LV SK BG