Brightness Brightness Setting; Sharpness Sharpness Setting; Osd Information Line For Zoom Factor And Focus; Protocol Protocol Selection For Control Via The - Monacor TVCCD-1622COL Mode D'emploi

GB
BRIGHTNESS
SHARPNESS
OSD
PROTOCOL
BAUD RATE
COMM.ID
Z-SEED
F-DETAIL
RESET
EXIT
BRIGHTNESS
SHARPNESS
Brightness and sharpness can each be set to a value be-
tween 0 and 20 with the button
value, the brighter or sharper the picture.
From the line BRIGHTNESS, it is possible to return to
the first menu page with the button
OSD information line for zoom factor and focus mode
In the setting ON, when the zoom button (1) or the button
AUTO (7) is pressed, the information line for the zoom fac-
tor and the focus mode (see chapter 6.2),
e. g. ZOOM X037 D AF, will shortly be displayed.
In the setting OFF, the information line will not be dis-
played.
26
" 10 #
" 10 #
ON
SK-S
6900
" 001 #
X3
X2
Fig. 11
Second menu page
brightness setting
sharpness setting
or : The higher the
.
protocol selection for control via the
PROTOCOL
RS-485 interface
For controlling the camera via the RS-485 interface (also
see chapter 5.2.1), select the protocol for the controller in
this line. Available are SK-S, PELCO-D, and PELCO-P.
transmission rate
BAUD RATE
For remote control via the RS-485 interface, adjust the
transmission rate of the controller in this line. Available are
2400, 4800, 9600, 19 200, 38 400, and 57 600 bauds.
COMM. ID identification number
For independent remote control of several units in the sur-
veillance system, an individual three-digit identification
number must be assigned to each unit. For the camera, a
number between 001 and 255 is available. The factory set-
ting is 001.
zoom speed
Z-SPEED
For the zoom speed, select the setting X1 (slow), X2 (aver-
age), or X3 (fast).
response of the manual focus setting
F-DETAIL
The setting X1 allows a most precise adjustment of the
manual focus with the buttons "N" and "F" (2), the setting
X2 allows a normal adjustment, and the setting X3 allows
a coarse adjustment.