Nailer Operation - Hitachi NR 90AF Manuel D'instructions Et De Sécurité

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English
3 Push the nail stopper toward the
magazine side, and pull out nails from the
back of the magazine.
Nails

NAILER OPERATION

Read section titled "SAFETY"(pages 5 – 8).
1
Nail feeder (A)
2
Nail feeder (B)
Nail stopper
3
DANGER
Operators and
others in work
area MUST wear
safety glasses
with side shields
which conforms
to ANSI Z87.1
specifications.
WARNING
NEVER point tool
at yourself or
others in work
area.
Keep
fingers
AWAY
trigger when not
driving nails to
avoid accidental
firing.
Choice of triggering method is
important.
Please read and understand "Methods
of Operation" below.
Before starting work, check the nailing
operation switching device.
This Hitachi nailer includes a nailing
operation switching device.
Before starting work, make sure that the
switching device is properly set.
If the switching device is not set properly,
the nailer will not operate correctly.
Never place your hands or feet closer
than 8 inches (200 mm) from firing
head when using.
Do not drive nails on the top of other
nails or with Nailer at too steep of an
angle; nails can ricochet and hurt
someone.
Do not drive nails into thin boards or
near corners and edges of workpiece.
Nails can be driven through or away
from workpiece and hit someone.
Never drive nails from both sides of a
wall at the same time. Nails can be
driven into and through the wall and
hit a person on the opposite side.
Never use Nailer which is defective or
operating abnormally.
Do not use Nailer as hammer.
Disconnect air hose from Nailer when:
1) it is not in use;
2) leaving work area;
3) moving it to another location; and
4) handing it to another person.
This Hitachi nailer is equipped with a nailer
operation switching device.
Use SINGLE SEQUENTIAL ACTUATION
MECHANISM or CONTACT ACTUATION
MECHANISM in accordance with the work
to be performed.
Explanation of the various nailing operations
SINGLE SEQUENTIAL ACTUATION
MECHANISM: First, press the push lever
against the workpiece; next, pull the
trigger to drive the nail.
from
After nailing once, nailing will not be
possible again until the trigger is released
and pressed again.
— 16 —

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Nr 90afs

Table des Matières