Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CONTACT ACTUATION MECHANISM:
First, press the push lever against the
workpiece; next, pull the trigger to drive
the nail.
First, pull the trigger; next, press the push
lever against the workpiece to drive the
nail.
If the trigger is held back, a nail will be
driven each time the push lever is
pressed against the workpiece.
PREVENTIVE MECHANISM FOR
UNLOADED OPERATION
The machine employs a preventive
mechanism for unloaded operation.
The machine enters a state where the push
lever stopper runs into the upper part of the
push lever and the push lever cannot be
pushed up. This takes place when the
magazine is not loaded with nails or when
the remaining number of nails becomes less
than 6 (This differs by the type of nail).
Load the nails immediately if you come
across with such a condition during
operation.
Push lever stopper
Push lever
CAUTION
Use caution not to throw the push lever
tip onto wood and the like while the
push lever stopper is in the upper part
of the push lever.
METHODS OF OPERATION
This Nailer is equipped with the push lever
and does not operate unless the push lever
is depressed (upward position).
There are two methods of operation to drive
nails with this Nailer.
They are:
1. Intermittent operation (Trigger fire):
2. Continuous operation (Push lever
fire):
(1) Intermittent operation (Trigger fire)
Use
the
ACTUATION MECHANISM setting.
For intermittent operation, set the
switching device to the upward
position completely. (i.e. Set to
SINGLE SEQUENTIAL ACTUATION
MECHANISM.)
To avoid double firing or accidental
firing due to recoil.
1) Set the switching device to SINGLE
SEQUENTIAL
MECHANISM.
2) Pull the trigger rapidly and firmly.
1 Set the switching device to the upward
position
SEQUENTIAL
MECHANISM).
(Set the switching device to the upward
6
position completely as shown in the
diagram. Otherwise, it will be set to
CONTACT ACTUATION MECHANISM.)
2 Position the nail outlet on the
workpiece with finger off the trigger.
3 Depress the push lever firmly until it is
completely depressed.
4 Pull the trigger to drive a nail.
5 Remove finger from the trigger.
To continue nailing in a separate location,
move the nailer along the wood, repeating
steps 2 - 5 as required.
— 17 —
English
SINGLE
SEQUENTIAL
WARNING
ACTUATION
(to
set
to
SINGLE
ACTUATION
1 Upward position
Switching device
Publicité
Table des Matières
