Hitachi NR 90AF Manuel D'instructions Et De Sécurité page 18

English
Trigger
4
3
Push lever
A nail will fire each time the trigger is
depressed as long as the push lever
remains depressed.
(2) Continuous operation (Push lever fire)
Using CONTACT
MECHANISM
To avoid double firing or accidental
firing due to recoil.
1) Do not press the nailer against the
wood with excessive force.
2) Separate the nailer from the wood
as it recoils after nailing.
1 Set the switching device to the
downward position (to set to CONTACT
ACTUATION MECHANISM).
(Set the switching device to the
downward position completely as
shown in the diagram. Otherwise, it will
not operate properly.)
2 Pull the trigger with the Nailer off the
workpiece.
3 Depress the push lever against the
workpiece to drive a nail.
4 Move the Nailer along the workpiece
with a bouncing motion.
Each depression of the push lever will
drive a nail.
As soon as the desired number of nails
have been driven, remove finger from the
trigger.
WARNING
ACTUATION
WARNING
Previously pull the trigger
4
Keep your finger off the trigger except
during fastening operation, because
serious injury could result if the push
lever accidentally contacts you or
others in work area.
Keep hands and body away from the
discharge area. This Hitachi nailer may
bounce from the recoil of driving a
fastener and unwanted subsequent
fastener may be driven, possibly
causing injury.
Some types of loaded nails can spark
out of the muzzle during a nail driving
operation. Exericise caution!
The SINGLE SEQUENTIAL ACTUATION
MECHANISM is for use where precision
fastener placement is desired.
— 18 —
Switching device
1 Downward position
2
Push lever
WARNING