Install Charging Cable - EVBOX WALL BOX 9835663180 Manuel D'installation

Part number: 9835663180

3. Install charging cable

Tools you need to install the charging cable
3.1
Unpack the charging cable box.
Remove the cardboard cover from the wall box's socket.
3.2
Take the charging cable out of the box.
Check that the rubber sealing ring on the charging plug is
in place and not twisted. This is to ensure that the proper IP
code (protection class) is met.
Place the wall box on its side and then plug the charging
cable into the wall box.
3.3
Make sure you press the charging cable until it is firmly
secured.
3.4
Turn the wall box around and put the front face of the wall
box on a soft surface. Place the bolt and firmly tighten the
bolt with the T30 bit.
Reconfirm that the cable bolt is tightened properly.
Check again that the charging cable is firmly connected to
the wall box.
INSTALLATION_WALL_BOX_PSA_B2C_MERGED.indd 17
1x bit T30
EN
17
11-9-2019 8:31:26