Switch Charging Cable (Optional) - EVBOX Elvi Manuel D'utilisation

EN
switch charging cable
(optional)
Tools you need to switch the cable
Bit T30
Step 1
Make sure your Elvi is powered off on the service
panel, the LED ring in the charging plug should
be off.
Remove the keys from the folder in the box.
Insert the keys into the slots on the bottom of the
wall dock. This releases the snap fit connection of the
charging station to the wall dock. Make sure to push
them in until they only stick out approx. 50 mm
and cannot be pushed any further.
Now you can remove your charging station from the
wall dock. Note that is still fixed on the connector
(socket) of the wall dock and will require some force to
pull it off. Take the charging station of in a straight line.
Do not twist or skew the charging station.
This might damage the station's snap fits.
Remove the keys from Elvi's wall dock.
Step 2
Turn the charging station around and put the front face
of the station on a soft and stable surface.
Untighten the bolt in the back with a T30 bit,
and take the bolt out.
Step 3
Take the cable out of the charging station.
Optimally, please store it in its original packaging.
Make sure to place the station on its side while
unplugging in the cable.
6