EVBOX WALL BOX 9835663180 Manuel D'installation page 13

Part number: 9835663180
EN
2. Install wall dock
2.1
Select a solid and flat vertical surface for installing
the wall dock.
Ensure that the surface is even and solid enough to
resist a pull force of at least 100 kg.
2.2
Find the drilling template at the bottom of the box's
sleeve. Cut the drilling template out from the sleeve.
2.3
Place the drilling template onto the wall and use a
level device (e.g. bubble level) to align the template.
Mark the 4 mounting points on the wall and remove
the template.
2.4
Drill holes with a drill round of 8 mm.
Use the provided 8x65 mm plugs.
2.5
Remove the protective rubber cap.
Undo the 4 corner screws (3x Torx T20 using the
supplied T20 bit and 1x slotted using a regular flat-
head screwdriver).
Remove the transparent cover from the wall dock.
2.6
Mount the wall dock onto the wall.
Use the provided 5x70 mm screws. Use the supplied
Torx T25 bit to fasten the screws.
14
INSTALLATION_WALL_BOX_PSA_B2C_MERGED.indd 14 11-9-2019 8:31:09