EdilKamin MYA Installation, Usage Et Maintenance page 35

INSTRUCTIONS FOR USE
This function allows you to select the type of programming, which allows a maximum of three ignitions to be set.
Use the "+" and "–" keys to switch between programmes.
By then pressing the "+" key, the following can be seen:
Use the "–" key to show in reverse order.
If the 1st programme is selected, the turn on time is shown.
The same applies for the turn-off time to be set and for subsequent turning on and off.
choosing number of interventions and at what times.
Should you make an error during programming, you can leave the programme without saving. As you press a key, , he di-
splay will show the word "no SAVE".
When the "M" key on the radio control is held down for two seconds and the display is scrolled using the "+" and "–" keys,
value set, pellet loading is decreased. By increasing the value set, pellet loading increases. This function is useful if
changing the pellet type for which the stove has been calibrated and loading therefore needs correcting.
-
stion chamber cleaning carried out automatically by the boiler.
The detection system is integrated into the electronic board, allowing you to see how many hours and kg are left until
- 35
-