Kimex 164-6540 Manuel D'utilisation page 130

SETWIFIAPSECURITY-
TYPE
GETWIFIAPSECURITY-
PASSWORD
SETWIFIAPSECURITY-
PASSWORD
GETWIFIAPSTATE
SETWIFIAPSTATE
GETWIFIAPCHANNEL
SETWIFIAPCHANNEL
GETWIFIAPTXPOWER
SETWIFIAPTXPOWER
sets the security type of
access point. The value
should be "none" or
"WPA2-PSK"
returns the password of
access point
sets the password of
access point. Password
must be maximum 64
characters
returns the access point
state 'active' or 'not
active'
sets the access point
state. State should be
'off' or 'on'
returns the stored
channel of the wifi
access point
sets the channel of the
wifi access point
returns TX Power for wifi
access point
sets TX Power for wifi
access point.
English - 40 -
string n ('none' or 'WPA2-
PSK' note: string is case
insensitive)
no parameter
string n (example:
'Password1234' )
no parameter
string n ( 'on' or 'off' note:
string is case insensitive)
no parameter
n (integer channel) -
(Channel number should
be valid for current country.
If invalid channel number
is given all valid channel
numbers will be listed.)
no parameter
n (integer tx power in dBm) -
should be in the range of 0 -
20 dbm (0 for default value)
#*Error! Security Type can not be
changed when Access Point is
active
or
#*Error! Security type parameter
should be given
or
#*Error! Security type parameter
is invalid
or
#*Security Type is set to (<TYPE>)
succeeded
#*Current stored Wifi AP Password
is (<PASSWORD>)
#*Error! Security Password can not
be changed when Access Point
is active
or
#*Error! Password length should
be between 8 and 63 characters
or
#*Setting Wifi AP Password
(<PASSWORD>) succeeded
#*Wifi Access Point is (<STATE>)
#*Error! Access Point state
parameter is invalid
or
#*Access Point state is already
(<STATE>)
or
#*Setting Wifi AP state (<STATE>)
succeeded
#*Current stored Wifi AP Channel
is (<channel>)
#*Setting Wifi AP Channel
(<channel>) succeeded
or
#*Wifi AP Channel is already
(<channel>)
or
#*Error! Invalid channel. Available
channels for your country
(<country name>) are: <all
available channels separated with
space>
#*Current Wifi AP TX Power is
<tx-power>
#*Setting Wifi AP TX Power (<tx-
power>) is successful.
or
#*Wifi AP TX Power is already set
to (<tx-power>)!
or
#*Error setting Wifi Access Point
TX Power (<tx-power>)! TX Power
should be in the range of 0 - 20
dbm (0 for default value)
or
#*Error setting Wifi Access Point
TX Power (<tx-power>)!