Kimex 164-6540 Manuel D'utilisation page 128

GETPORTALMODE
SETFRONTPANEL-
CLOCK
GETMODELNO
SETMODELNO
GETSERIALNO
SETSERIALNO
DEACTIVATENETFLIX
GETTVLIFETIME
SETPOWERONDELAY
GETPOWERONDELAY
SIGNAGERESET
SETFTIPIN
GETFTIPIN
SETUSERSECLEVEL
GETPROFILEINFO
SILENTRESET
GETCPUTEMPERATURE Gets cpu temperature
GETRAMUSAGEPER-
CENTAGE
Gets tv is portal mode
or not.
Sets front panel clock
time( values : 10:00 ,
12:30 ,... ).
Get model no.
Set model no.
Get serial no. (returns
#*NACK if no serial
number has been set)
Set serial no.
Remove account
informations of Netflix.
Prints panel life time in
minutes.
Set poweron delay level
Get poweron delay level
Set all items in the
signage settings menu to
their default values.
Set FTI PIN number
Get FTI PIN number
Set user security level
Get Profile Info
Resets the device
without coming up
backlight.
Gets ram usage
percentage
English - 38 -
no parameter
string-integer n( 10:00,
14:00, ...)
no parameter
string-integer n
no parameter
string-integer n
no parameter
no parameter
integer n (0<=n<=20, delay
is calculated as 100ms*n)
no parameter
no parameter
integer n (n is a four digit
number)
no parameter
string - string (new security
level(NORMAL / ADMIN) -
password)
Please request the password
from your supplier.
no parameter
no parameter
no parameter
no parameter
#*tv_portal_status:0
#*Portal status 0 is sent to listening
socket(if open)
or
#*tv_portal_status:1
#*Portal status 1 is sent to listening
socket(if open)
#*Time is set succesfully.
or
#*Given time parameter is wrong!
Time is not set.!(Param : 10:00 ,
12:30 , ...)
#*Model no: ...
#*ACK
or
#*NACK
#*<Serial no>
or
#*NACK
#*ACK
or
#*NACK
#*Account informations were
deleted for Netflix
or
#*Remove failed for Netflix
account.
#*TV Life Time: n
#*Poweron delay set to ... ms
or
#*NACK
#*The power on delay is ... ms
#*All signage settings set to default
values
#*FTI PIN was set to n
or
#*PIN can not be set to n
#*The FTI PIN is n
#*User security level was set to ...
#*Profile name: mbXXX_draft_
profile
#*This command is available only
Active Standby state!
or
#*Reset operation was not
successful
#*cpu temperature is ...
#*memory usage percentage is ...
or
#*can not get memory usage
percentage