Kimex 164-6540 Manuel D'utilisation page 107

Controls
OSD Orientation
Browser
Orientation
Pixel shift
No Signal
No Signal Delay
No Signal Power
Off
Panel Lock
RCU Inhibit
UART 0
Sets the OSD (On Screen Display) rotation of your Display. Landscape, Portrait 1
and Portrait 2 options are available.
Sets the rotation of the browser. Landscape, Portrait1 and Portrait2 options are
available. One of the portrait options will be set by default depending on the model.
This option will rotate the browser only and the changes will be applied after the
Display is switched off and back on again.
Note: Portrait mode does not support html pages which include videos.
Enables or disables pixel shifting. This option can be used to avoid image retention
(after image effects) that can occur when displaying fixed patterns or still images for
long periods of time. If enabled, the picture and OSD (On-Screen Display) will be shifted
at specified time intervals.
Sets the behavior preference of the Display, when no signal is detected from the currently
set input source. Failover and Input Search options are available.
If Failover is selected the Display checks the connected USB device for available
files to play. If no playable files are available or there is no USB device connected to
the Display, the No Signal image will be displayed. If there isn't any No Signal Image
available, No Signal OSD will be displayed on the screen. The setting of the USB Auto
Play option in the Settings>System>More menu is not important, in Failover mode it
will function anyway.
If Input Search is selected the Display will search all available input sources consecutively
to find signal. If no signal is detected from other available sources, No Signal OSD will
be displayed and the Display will turn itself off after a period of 30 seconds.
Sets a delay value to the 'No Signal' preferences when the Display is in No Signal state.
After the set delay time is expired 'No Signal' preferences will be applied. If the No Signal
option is set as Input Search, this option will not be available.
When enabled the Display will turn itself off after a period of 5 minutes, if no signal is
received from the selected source.
This feature will only work if all of the following circumstances occur:
- No Signal option is set as Failover.
- USB device is not connected to the Display / USB device is connected but there are
no playable files installed on the USB device.
If the No Signal option is set as Input Search, this option will not be available.
Set as Off to prohibit the use of the buttons on the Display.
Set as On to inhibit the use of the remote. Remote control will function in Stand-By
mode independently from the setting of this option.
To turn this option off and be able to use the remote again, press MENU/M-1-9-7-3
buttons on the remote consecutively. Signage menu will appear. Enter the Controls
menu and set this option as Off.
Select ASCII/HEX protocol for UART 0. Default value is ASCII. There is no need to
restart the Display after selection in order to work with the protocols correctly. If the
selection is changed, the latest selected protocol will be preserved and started when
the Display is booted up.
Note that ASCII/HEX selection is not working while debug logs are enabled. If it is
wrongly changed to HEX while debug logs are enabled, revert the selection to ASCII and
reboot the Display in order to correct the debug logs and the ASCII protocol behaviour.
Also note that HEX protocol will work with the baud rate value 19200 for UART 0.
English - 17 -