Safety Regulations; Proper Use - EINHELL 41.327.27 Mode D'emploi D'origine

Anleitung_DSL_250_2_SPK7:_
GB
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.

1. Safety regulations

CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
Take suitable precautions to protect yourself and
your environment from potential hazards.
Never put the pin grinder to any use other than
that intended.
Always concentrate while you work. Do not work
if you are tired.
Use only a quick-release coupling to connect up
the air supply.
It is imperative to use a pressure reducer to set
the working pressure.
Never use oxygen or combustible gases as an
energy source.
Always disconnect the tool from the air supply
before carrying out any repairs or maintenance
work.
Use only original replacement parts.
Never allow the tool to run unloaded at full idle
speed for any considerable length of time.
Wear the necessary protective clothing when
working with the pin grinder.
Always wear goggles when grinding.
Watch out for sparks when grinding. Hot flying
particles may burn into both soft and hard
materials (glass, floor coverings, etc.) or ignite
inflammable solids and liquids (hay, saw dust,
lacquer, etc.).
Never use the machine without oil.
Check the condition of the grinding pins regularly.
Store the grinder where it is out of the reach of
children.
8
22.03.2012 8:14 Uhr Seite 8
Securely fasten the workpiece you want to grind.
Use only organically bonded grinding wheels and
organically or inorganically bonded grinding pins
and small grinding wheels (wheel Ø smaller than
20 mm).
Under no circumstances are you to use grinding
wheels at speeds higher than the speed quoted in
min-1 by the wheelʼs manufacturer.
Allow new grinding wheels a running-in period of
30 seconds on the tool. Operators and other
personnel are to stay out of the danger zone
during the trial run. Hold the rotating grinding pin
away from the body.
Never halt a grinding wheel by pressing on its
circumference or face.
Tighten the lock nut only enough to hold the
grinding wheel securely in place.
Operators are to be thoroughly instructed on how
to use the grinding tool safely.
Always examine the grinding pins for signs of
damage before you start to work.
Handle grinding pins and other abrasives
carefully. Do not drop. Avoid knocks.
Make sure the pneumatic motor and the toolʼs
bearings are kept properly lubricated, particularly
after a long period of use.
When fitting a grinding pin, be sure to leave a gap
of at least 1 cm between the back of the abrasive
and the tool lock nut.
Make sure that the air hose connections and hose
couplings are tight and that the air pressure is the
same as that specified in the instructions.
2. Layout (Fig. 1)
1 trigger lever
2 connector
3 adapter sleeve mount
4 adapter sleeve + lock nut
5 plug-in nipple for the air supply

3. Proper use

The pin grinder is a handy pneumatic tool for use in
DIY and automotive workshops.
The exhaust air leaves the tool through the outlet to
the rear. The air supply is connected to the tool by
means of a quick-release coupling.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries