Night Mode - Dyson Pure Hot+Cool Link HP02 Manuel D'utilisation

Night mode

The night mode will dim the display and run quietly, making it ideal for use while sleeping.
When night mode is enabled (indicated by an illuminated half
moon symbol in the bottom right corner of the display), the display
will dim and after 5 seconds will fade to off. The half moon symbol
remains illuminated.
If the appliance is not in auto mode, the airflow speed will reduce to level 4. When night mode is activated, if it is already below level 4, it will remain
the same. This can be manually changed if desired. The display will illuminate briefly, then fade as before. If in auto mode the airflow speed will be
reduced automatically.
Oscillation
Diffused and focused modes
52
Oscillation control
To start the appliance oscillating,
press the oscillation control
button. To stop the appliance
oscillating, press it again. The
appliance will not oscillate when
the control buttons are pressed.
Diffused mode
Press the wide angle button to
change from a personal directed
airflow to wider projection of
air flow.
Heating and cooling modes work
in this mode.
5 secs
Heating and cooling modes
Airflow speed control
To change the airflow speed
press the airflow control button.
The digital display will show
the new fan speed. If in heater
mode after 2.5 seconds it will
change back to displaying the
target temperature.
Focused mode
Press the narrow angle button to
change from a wider projection
of airflow to a personal
directed airflow.
Heating and cooling modes work
in this mode.