Dimming Function For Infrared Heater/Infrared Plate - Sentiotec infrabox Instructions De Montage Et Mode D'emploi

Instructions for use for the user

9.4. Dimming function for infrared heater/infrared plate

Controlling (dimming) the infrared heater/infrared plate is possible in 5 levels.
At 0 the infrared heater/infrared plate is switched off, at 5 it is a full capacity.
Function only possible in operating modes: leading edge phase control and
half-wave control
To activate the function, additional settings are required, see chapter 6.2. Operat-
ing type (infrared heater/infrared plate) on page 21
Function only possible in operating mode: normal and seat
To activate the function, additional settings are required, see chapter 6.1. Oper-
ating mode on page 20
1. Press the Mode button.
► The light symbol for infrared heater/infrared plate 6 lights up.
2. Use the intensity selector 1 and 2 to set the preferred intensity of heat.
► The light operates at the level of intensity selected.
p. 37/44
EN