Important Information For Your Safety; Intended Use - Sentiotec infrabox Instructions De Montage Et Mode D'emploi

Instructions for installation and use

2. Important information for your safety

The infrared controller has been produced in accordance with the
safety regulations applicable for technical units. However, hazards
may occur during use. Therefore adhere to the following safety
information and the specific warning notices in the individual chap-
ters. Also observe the safety information for the devices connected.

2.1. Intended use

The Infrabox infra controller is used exclusively for controlling and
operating the light/fan and infrared heater/infrared plate.
The Infrabox infrared controller is only suitable for use
with intrinsically safe infrared heaters and infrared plates.
If no intrinsically safe products are being used, a safety
temperature limiter must be connected.
Observe the instructions for this in the operating instruction manual.
The infrared controller may only be used for controlling a maximum
capacity of 3.5 kW.
Overview of the operating modes:
Switchable: up to 3.5 kW
Half-wave control (dimmable): up to 1.3 kW
Leading edge phase control (dimmable): up to 350 W
p. 5/44
EN