Switching Off; Chap. 5. Maintenance, Breaks Research And Cleaning; Maintenance Man Requirements; Maintenance Prescriptions - Fama TS 12 Manuel D'utilisation

PUT IN FUNCTION
The machine operator can put in function the machine following in order the under reported indications:
1. Controls positive result for the preparation preliminary operations,
2. Controls positive result for the electric feeding,
3. Controls positive for the hopper inserting and positioning
4. Checks positive result for the grinding group assembly,
5. Checks positive result for the Archimedean screw correct rotation,
6. Checks positive result / verifications before starting and periodical,
7. Finalized checks positive result and verify the all safety conditions respect,
8. Plug connection in opportune current socket,
9. Place a gathering basin in the machine anterior zone in correspondence of the ground meat exit zone,
10. Put in the machine left side and start the machine acting the control device of start "I",
11. Introduce manually the food product within the machine neck and drive it towards the Archimedean screw using the
pestle in equipment.
12. At the end of the food product introduction, or when from the drilled plate doesn't come out more the product, stop the
machine acting the control device of stop "0".
It is recommended to make not work the machine in vain, without the food product

SWITCHING OFF

In succession, the switching off must follow what here under indicated:
1. Before the switching off wait the food product exile conclusion from the drilled plate,
2. Stop the machine acting the control device of stop "0",
3. Disconnect the machine plug from the feeding socket,
4. Perform the cleaning interventions
UNBLOCK IN CASE OF OBSTACLE
During the working, or during the Archimedean screw rotation, due to the food products introduction with not homogeneous
parts, as for example bones, or other, the machine could block.
The same situation can determine after an electric feeding break, or when the machine is stopped with inside the food product.
To be able to resume normally the working, the grinding group must be disassembled, with the different differentiation: the
disassembly must not happen slacking the blockage wheel, but slacking the grinding mouth block knob.

CHAP. 5. MAINTENANCE, BREAKS RESEARCH AND CLEANING

MAINTENANCE MAN REQUIREMENTS

With the term "maintenance" must not be understood only the periodical check of the machine normal functioning but also
the analysis and the consequent remedy of all causes that for any matter put it out of service. It is absolutely necessary that for
the maintenance, cleaning, parts change and breaks research activities performed from the user, this work is entrusted to
skilled personnel, competence and authorized from the employer.
All operations of maintenance, cleaning and parts change, none excluded, must be definitely performed with the machine
completely stopped and insulated from the external feeding sources.

MAINTENANCE PRESCRIPTIONS

PROTECTIONS REMOVAL AND/OR PROTECTION DEVICES
For any interventions described in the present chapter, it is necessary to remove from their position some fixed
protections.
The removal can happen only from the maintenance man.
At the end of the interventions, these protections must be replaced and blocked in their original position, with the fastening
systems which were foreseen before the intervention.
The maintenance responsible must disconnect completely the machine, as here follow reported, before to proceed with the
removal of a fixed protection and/or with the element change.
ORIGINAL INSTRUCTIONS TRANSLATION
.
Pag.
14
di
18