Simbology Meaning; Chap. 2. General Information And Characteristics - Fama TS 12 Manuel D'utilisation

SIMBOLOGY MEANING

Here follow it is clearly specified the symbols and definitions meaning, which will be used in the present document.
DANGER
Show the danger presence for who works on the machine and for who is in the vicinity, so the indicated activity
must be performed in accordance with the actual accident prevention standards and with the indications showed
in the present manual
PRECAUTION
Show a warning on useful information and/or further recommendations and/or shrewdness about the actual
operation.
ATTENTION
Show an operation to perform with attention to avoid damage to the machine.

CHAP. 2. GENERAL INFORMATION AND CHARACTERISTICS

USE DESTINATION AND MANUFACTURE PARTS
Meat mincer designed to be used with plate holes diameter smaller or equal to 8mm.
The mincer – grater, here follow is called "machine", è designed to mince, reduce of size fresh meat not frozen, through
cutting tools to obtain meat sauce, hamburgers, meatballs and sausages. The meat must be without bones, or other parts of
different consistency from the meat.
With the grater group placed on the opposite side of the machine, to grater tough cheese, bread and biscuits.
The machine is constituted from an electric motor inserted in a unique merger (basic machine body). In some versions the
merger can be recovered from a bonnet (hulled machine body).
The meat to grind, is loaded manually in the load hopper, placed in the superior zone of the machine and always manually and
with the pestle help is introduced in the grinding neck towards the Archimedean screw.
The hopper is blocked to the machine neck. The pestle is of plastic material suitable for the contact with food products.
The grinding group is of different typologies: Enterprise it comes with 6mm plate holes diameter, Half Unger, Total
Unger.
The plate in turn is pressed against the cutter from the wheel inserted on the grinding group mouth.
The grinding group is dismanteable, all direct contact materials with the food material are in conformance with the actual
hygienic standards for food.
In accordance with the functioning requirements and production, the machine can be constituted with different optional parts.
The machine is supplied with the identification plate on which the following data are showed:
[fac simile]
ORIGINAL INSTRUCTIONS TRANSLATION
Pag. di
4 18