Lenz Digital Plus GOLD maxi Mode D'emploi page 45

Bit Settings 1
29
1 (0) Direction of travel
0 normal: locomotive drives forward if the arrow on the manual
control points up.
1 interchanged: locomotive drives forward if the arrow on the
manual control points down.
2 (1) Running-notches mode:
0 Operation with 14 or 27 running notches.
This setting is chosen for digital systems which do not
support the 28 running-notches mode.
1 Operation with 28 or 128 running notches.
This setting is chosen for digital systems which support the
28/128 running-notches mode.
3 (2) Operational mode:
0 Locomotive only runs in digital operation.
1 Locomotive runs both in digital and conventional operation,
flying splice possible.
4 (3) 0 RailCom transmission disabled
1 RailCom transmission enabled
5 (4) 0 factory pre-set speed curve is used
1 User defined speed curve is used
6 (5) 0 Decoder uses basic address (from CV1)
1 Decoder uses extended address (from CV17 and CV18)
7-8(6-7) Not used
45
6 (dec)
0
E
1
1
0
0
0
0