Lenz Digital Plus GOLD maxi Mode D'emploi page 33

2 Installing the GOLD decoder via cable connection (Abb. 1, p.4)
Please note which motor connection is connected to the right rail pickups and which to the left. If
you do this, you will not have to try out which of the two motor outputs M1 and M2 of the decoder
needs to be connected to which motor connection to set the desired direction of travel. After
removing the existing cables, the motor connections must be potential-free. This means that they
must not be connected in any way to the chassis or the rail pickups of the locomotive. Bear in mind
that sometimes a connection like this is only made when the chassis is put back! Please contact a
service centre if you are in any doubt as to whether all necessary preconditions for the installation
are fulfilled!
First connect the decoder to the pickups of the locomotive:

Input G1 to the right rail pickup

Input G2 to the left rail pickup
Then connect the decoder to the motor connections:

Motor output M1 to the motor output previously connected to the right rail pickup

Motor output M2 to the motor output previously connected to the left rail pickup
Now, connect the functions. Ex-works, the function outputs are set as follows: Outputs A and B
react to F0, depending on the direction of travel. This setting can be changed.
If you would like to keep the default settings of the function outputs, connect the outputs as follows:

Function output FA to the front lighting at the front in the direction of travel

Function output FB to the front lighting at the back in the direction of travel
If a connection between the bulbs and chassis exists, the connection of the front lighting is
completed. If the bulbs are not electrically connected to the locomotive chassis (we call this
33
E