Editing The Orders - Sony MPS-V500 Mode D'emploi

Editing the orders

You can change the print size and quantity of the recorded orders.
1
Display the ORDER screen, and select "EDIT" to display the EDIT screen.
PIC_NO: Picture number
SIZE: Print size
QTY: Print quantity (number of prints)
C: "*" means that the picture is cropped.
P: "*" means that the picture has been printed.
P RESTOR: See page 23.
2
Change the print size and/or quantity.
/
Press the keys to move the cursor (z) to the line of
the picture of which you want to edit the order, and
ı/
press the keys to select SIZE (print size) or QTY
(print quantity). Press the ZOOM +/– keys to change
the order.
Make necessary changes for each picture.
You cannot edit the previously printed orders that are
identified by an "*" mark in the P column. To edit these
orders, restore them to unprinted status. See page 23.
3
Press the EXEC/ROTATE key.
"EDIT?" appears.
4
Press the EXEC/ROTATE key again to record the
edited orders on the MD.
When recording finishes, "COMPLETE" appears, then
the display returns to the EDIT screen.
To cancel the edited orders without recording, press the
CANCEL/MIRROR key instead of the EXEC/ROTATE
key.
5
Press the CANCEL/MIRROR key to make the
ORDER screen disappear.
Press it once to return to the ORDER screen, or twice to
return to the picture display.
22
(EN)
MPS-V500/V500P (U/C/CED/GA).3-856-662-11 (1).EN
Number of unprinted
orders
Number of all the orders
Note
Do not disconnect the battery or
DC cord during recording. Doing
so may damage the data on the
MD.
Error messages
• If you edit many orders at a time,
"EDIT FULL" appears. In this
case, press the EXEC/ROTATE
key to record the changes, then
make more changes.
• If the battery is too weak to
record, "LOW BATT" appears.
Replace it with another battery
or recharge it.